Poly-Hanger #1 supports one or more layers of poly in front of walls. It easily slips behind wall molding and is supported by the vertical leg of the molding. Poly-Hanger #1 will also support poly in front of masonry or paneling by nailing into a joint which can be easily patched after tear down.
And best of all, they are REUSABLE!
Securely hang poly sheeting directly to wall moldings of acoustic ceilings
Eliminates damage to wall surfaces and resulting clean-up costs
Simple to install, remove and reuse on the next job
Increases productivity and saves on labor
Eliminates using spray glue to support poly sheeting
Prevents poly sheeting from falling down
Install Hangers approximately 3' apart. Hang the poly sheeting on the prong keeping the top of the poly just below the wall molding. Complete the containment by taping between the poly and the molding and by taping over the prong (use our non-porous 2” Red Serrated-Edge Tape).
Poly-Hanger #1 can be used to support poly in front of masonry by nailing in a joint using a tension pin (i.e., tempered steel molding nail available at drywall supply houses).
Poly-Hanger #1 is removed by gently pulling down on the outer tip of the wall molding which causes the back vertical leg to rotate away from the wall and then can be slid downward.
Case lots only